Monitoring Application Terminate Reason Mappings - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

Related
Documentation

Monitoring Application Terminate Reason Mappings

Purpose
Action
Copyright © 2010, Juniper Networks, Inc.
Table 32: show subscribers Output Fields (continued)
Field Name
Subscribers
Ppp
Ip
Tnl
Total
Domain Name
ICR-Partition (location-id)
Count
Slot
show subscribers
Display information about the mappings for application terminate reasons.
To display the current terminate reasons that are mapped to a specific
Acct-Terminate-Cause-Code:
This example uses the radius keyword to display all current terminate reasons mapped
to RADIUS Acct-Terminate-Cause codes. The output lists all PPP mappings, followed
by L2TP mappings, and then AAA mappings.
host1(config)#run show terminate-code radius
Apps Terminate Reason
--------- --------------------------
ppp authenticate-authenticator
-timeout
ppp authenticate-challenge-tim
eout
ppp authenticate-chap-no-resou
rces
ppp authenticate-chap-peer-aut
henticator-timeout
Chapter 2: Monitoring and Troubleshooting Remote Access
Field Description
Number of subscribers; the sum of the Ppp and Ip
fields
Number of PPPoA and PPPoE users, combined
Number of DHCP and IP subscriber manager users,
combined
Number of users tunneled to an LNS
Total number of users per virtual router; the sum of
the Ppp, Ip, and Tnl fields
Domain name used by the subscriber
A unique identifier for each ICR partition on a chassis.
Note that this ID different from the partition name,
which is configured using the ip vrrp vrid
icr-partitionpartitionName command.
Number of subscribers
Number of slot in the chassis
Description
--------------------------
authenticate authenticator
timeout
authenticate challenge tim
eout
authenticate chap no resou
rces
authenticate chap peer aut
henticator timeout
Radius
Code
------
17
10
10
17
159