Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 397

Copyright © 2010, Juniper Networks, Inc.
host1(config-domain-map)#router-name default
Specify a tunnel to configure and enter Domain Map Tunnel Configuration mode:
3.
host1(config-domain-map)#tunnel 3
Specify the LNS endpoint address of a tunnel.
4.
host1(config-domain-map-tunnel)#address 192.0.2.13
(Optional) Assign a tunnel group to the domain map. You can assign a tunnel group
5.
only when no tunnels are currently defined for the domain map from AAA Domain
Map Tunnel mode.
host1(config-domain-map)#tunnel group storm
Specify a preference for the tunnel.
6.
You can specify up to eight levels of preference, and you can assign the same
preference to a maximum of 31 tunnels. When you define multiple preferences for a
destination, you increase the probability of a successful connection.
host1(config-domain-map-tunnel)#preference 5
(Optional) Specify an authentication password for the tunnel.
7.
host1(config-domain-map-tunnel)#password temporary
NOTE: If you specify a password for the LAC, the router requires that the
peer (the LNS) authenticate itself to the router. In this case, if the peer
fails to authenticate itself, the tunnel terminates.
(Optional) Specify a hostname for the LAC end of the tunnel.
8.
The LAC sends the hostname to the LNS when communicating to the LNS about the
tunnel. The hostname can be up to 64 characters (no spaces).
host1(config-domain-map-tunnel)#client-name host4
NOTE: If the LNS does not accept tunnels from unknown hosts, and if no
hostname is specified, the LAC uses the router name as the hostname.
(Optional) Specify a server name for the LNS.
9.
This name specifies the hostname expected from the peer (the LNS) when you set
up a tunnel. When this name is specified, the peer must identify itself with this name
during tunnel startup. Otherwise, the tunnel is terminated. The server name can be
up to 64 characters (no spaces).
host1(config-domain-map-tunnel)#server-name boston
(Optional) Specify a source IP address for the LAC tunnel endpoint. All L2TP packets
10.
sent to the peer use this source address.
host1(config-domain-map-tunnel)#source-address 192.0.3.3
Chapter 12: Configuring an L2TP LAC
359