Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 705

aaa service accounting interval
aaa user accounting interval
Copyright © 2010, Juniper Networks, Inc.
Table 149: Sample Acct-Start Message for a Service Session (continued)
RADIUS Attribute
nas-port-type
nas-port
nas-port-id
acct-authentic
acct-session-time
acct-service-session
service-interim-acct-interva
l
Use to specify the default interval between service accounting updates. Service manager
uses the default interval when no value is specified in the Service-Interim-Acct-Interval
attribute (Juniper VSA 26-140).
This command and the aaa user accounting interval command replace the aaa
accounting interval command, which is deprecated and might be removed in a future
release.
The default interval is applied on a virtual router basis—this setting is used for services
associated with all users who attach to the corresponding virtual router.
Specify the service accounting interval, in the range 10–1440 minutes. The default
setting is 0, which disables the feature.
NOTE: To enable interim service accounting, the service accounting interval
must be set to a non-zero value and the service statistics type must not be
set to none.
Example
host1(config)#aaa service accounting interval 60
Use the no version to reset the accounting interval to 0, which turns off interim service
accounting when no value is specified in the Service-Interim-Acct-Interval attribute
(Juniper VSA 26-140).
See aaa service accounting interval
Chapter 27: Configuring Service Manager
Sample Value
15
3221225472
FastEthernet 12/0
1
0
tiered(1280000, 5120000)
1200
667