JunosE 11.3.x Broadband Access Configuration Guide
radius include egress-policy-name
radius ignore egress-policy-name
radius ignore atm-service-category
218
Example
host1(config)#radius ignore ingress-policy-name enable
Use the no version to restore the default, enable.
[26-11] Egress-Policy-Name
Use the following commands to manage the Egress-Policy-Name RADIUS attribute.
radius include egress-policy-name
radius ignore egress-policy-name
Use to include the Egress-Policy-Name attribute in Acct-Start or Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include egress-policy-name acct-start enable
Use the no version to restore the default, enable.
Use to cause the Egress-Policy-Name attribute to be ignored in Access-Accept
messages.
You can control this behavior by enabling or disabling this command.
See radius ignore
Example
host1(config)#radius ignore egress-policy-name enable
Use the no version to restore the default, disable.
[26-14] Service-Category
Use the following command to manage the Service-Category RADIUS attribute.
radius ignore atm-service-category
Use to cause the Service-Category attribute to be ignored in Access-Accept messages.
You can control this behavior by enabling or disabling this command.
See radius ignore
Example
host1(config)#radius ignore atm-service-category enable
Copyright © 2010, Juniper Networks, Inc.