Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 105

aaa profile
nas-port-type atm
Copyright © 2010, Juniper Networks, Inc.
host1(config)#aaa profile nasPortType
(Optional) Set the NAS-Port-Type attribute for ATM interfaces.
2.
host1(config-aaa-profile)#nas-port-type atm wireless-80211
(Optional) Set the NAS-Port-Type attribute for Ethernet interfaces.
3.
host1(config-aaa-profile)#nas-port-type ethernet wireless-cable
Use to create and configure a AAA profile.
Example
host1(config)#aaa profile nasPortType
Use the no version to delete the AAA profile.
See aaa profile
Use to specify the RADIUS NAS-Port-Type attribute (61) for ATM interfaces. You can
set the attribute to:
value—Number in the range 0–65535
adsl-cap—Asymmetric DSL, carrierless amplitude phase (CAP) modulation
adsl-dmt—Asymmetric DSL, discrete multitone (DMT)
cable
iapp—Inter Access Point Protocol (IAPP)
idsl—ISDN DSL
sdsl—Symmetric DSL
wireless-1x-ev—Wireless 1xEV
wireless-80211—Wireless 802.11
wireless-cdma—Wireless code division multiple access (CDMA)
wireless-other
wireless-umts—Wireless universal mobile telecommunications system (UMTS)
xdsl—DSL of unknown type
Example
host1(config-aaa-profile)#nas-port-type atm wireless-80211
Use the no version to remove the NAS-Port-Type setting for ATM interfaces.
See nas-port-type atm
Chapter 1: Configuring Remote Access
67