[26-46] Ipv6-Local-Interface; [26-47] Ipv6-Primary-Dns; [26-48] Ipv6-Secondary-Dns - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x Broadband Access Configuration Guide
radius include ipv6-local-interface
radius include ipv6-primary-dns
222

[26-46] Ipv6-Local-Interface

Use the following command to manage the Ipv6-Local-Interface RADIUS attribute.
radius include ipv6-local-interface
Use to include the Ipv6-Local-Interface attribute in Acct-Start, or Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
For this attribute, the value received from the RADIUS server in the Access-Accept
message is used in the accounting messages.
If IPv6 local interface is configured in the AAA domain map and is not returned from
the RADIUS server, the Acct-Start, Acct-Stop, or Interim-Acct messages report the
value configured in the domain map.
See radius include
Example
host1(config)#radius include ipv6-local-interface acct-start enable
Use the no version to restore the default, disable.

[26-47] Ipv6-Primary-DNS

Use the following command to manage the IPv6-Primary-DNS RADIUS attribute.
radius include ipv6-primary-dns
Use to include the IPv6-Primary-DNS attribute in Acct-Start, or Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
For this attribute, the value received from the RADIUS server in the Access-Accept
message is used in the accounting messages.
If the IPv6 primary DNS server is configured in the AAA domain map and is not returned
from the RADIUS server, the Acct-Start, Acct-Stop, or Interim-Acct messages report
the value configured in the AAA domain map.
See radius include
Example
host1(config)#radius include ipv6-primary-dns acct-start enable
Use the no version to restore the default, disable.

[26-48] Ipv6-Secondary-DNS

Use the following command to manage the Ipv6-Secondary-DNS RADIUS attribute.
Copyright © 2010, Juniper Networks, Inc.