Monitoring Detailed Configuration Information For Specified Destinations - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

Related
Documentation

Monitoring Detailed Configuration Information for Specified Destinations

Purpose
Action
Copyright © 2010, Juniper Networks, Inc.
Table 83: show l2tp Output Fields (continued)
Field Name
Failover resync
Sub-interfaces
total
active
failed
auth-errors
show l2tp
Display detailed configuration information about specified destinations.
To display detailed configuration information about specified destinations:
To display information about a specific destination:
host1#show l2tp destination ip 172.31.1.98
L2TP destination 1 is Up with 5 active tunnels and 64 active sessions
To display information about all destinations:
host1#show l2tp destination detail 1
L2TP destination 1 is Up with 5 active tunnels and 64 active sessions
Configuration
Administrative state is enabled
SNMP traps are enabled
Destination address
Transport ipUdp
Virtual router default
Local address 192.168.1.230, peer address 172.31.1.98
Destination status
Effective administrative state is enabled
Sub-interfaces total active failed auth-errors
Tunnels 5 5
Sessions 64 64
Statistics packets
Control rx 69
Control tx 195
Data rx 68383456
Data tx 68383456
Chapter 16: Monitoring L2TP and L2TP Dial-Out
Field Description
Global L2TP peer resynchronization configuration
Sub-interface information about L2TP
Number of destinations, tunnels, and sessions that
the router created
Number of operational destinations, tunnels, and
sessions
Number of requests that did not reach an operational
state
Number of requests that failed because the tunnel
password was invalid
0 0
0 n/a
octets discards
3251 2
23939 0
68383456 0
68383456 0
errors
0
0
0
0
433