JunosE 11.3.x Broadband Access Configuration Guide
488
Figure 12: Non-PPP Equal-Access Configuration Example
The following steps describe how to configure this scenario.
Configure interfaces on the router.
1.
host1(config)#interface loopback 0
host1(config-if)#ip address 10.10.1.1 255.255.255.255
host1(config-if)#ip address 10.10.2.1 255.255.255.255 secondary
host1(config-if)#exit
host1(config)#interface fastEthernet 2/0
host1(config-if)#ip unnumbered loopback 0
Configure the parameters to enable the router to forward authentication requests to
2.
the RADIUS server.
host1(config)#radius authentication server 10.10.1.2
host1(config)#udp-port 1645
host1(config)#key radius
Specify the authentication method.
3.
host1(config)#aaa authentication ppp default radius
Or
host1(config)#aaa authentication ppp default none
Copyright © 2010, Juniper Networks, Inc.