[41] Acct-Delay-Time; [44] Acct-Session-Id - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x Broadband Access Configuration Guide
radius remote-circuit-id-delimiter
Related
Documentation
radius include acct-delay-time
202
Use the no version to restore the default format, agent-circuit-id.
Use to configure the delimiter character that the router uses to set off multiple
components in the format of the PPPoE remote circuit ID value captured from a DSLAM.
For information about how to use this command, see the Configuring PPPoE Remote
Circuit ID Capture section in JunosE Link Layer Configuration Guide.
See radius remote-circuit-id-delimiter
Example
host1(config)#radius remote-circuit-id-delimiter !
Use the no version to restore the default delimiter character, #.
Monitoring Override Settings of RADIUS IETF Attributes on page 303
Monitoring the NAS-Identifier RADIUS Attribute on page 305
Monitoring the Format of the Remote-Circuit-ID for RADIUS on page 305
Monitoring the Delimiter Character in the Remote-Circuit-ID for RADIUS on page 306

[41] Acct-Delay-Time

Use the following commands to manage and display information for the Acct-Delay-Timer
RADIUS attribute.
radius include acct-delay-time
Use to include the Acct-Delay-Time attribute in Acct-On or Acct-Off messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include acct-delay-time acct-on enable
Use the no version to restore the default, enable.

[44] Acct-Session-Id

Use the following commands to manage and display information for the Acct-Session-Id
RADIUS attribute.
radius include acct-session-id
radius acct-session-id-format
Copyright © 2010, Juniper Networks, Inc.