Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 729

ip http same-host-limit
ip http server
ipv6 http
ipv6 http port
Copyright © 2010, Juniper Networks, Inc.
Use the no version to restore the default, which disables the HTTP redirect feature.
See ip http redirectUrl
Use to specify the maximum number of connections that can exist between one IP
address and the HTTP local server.
Specify a number in the range 0–1000.
Example
host1(config)#ip http same-host-limit 20
Use the no version to restore the default number of allowed connections, 3.
See ip http same-host-limit
Use to enable the HTTP local server to listen for and process IPv4 exception packets.
Example
host1(config)#ip http server
Use the no version to disable the HTTP local server.
See ip http server
Use to create the HTTP local server to listen and process for IPv6 exception packets.
Example
host1(config)#ipv6 http
Use the no version to delete the HTTP local server.
See ipv6 http
Use to specify the port on which the HTTP local server receives connection attempts
for IPv6 exception packets.
NOTE: You can modify the port on which the HTTP local server receives
connection attempts. However, you must first disable the HTTP local server
and then modify the port.
Specify a port number in the range 1–65535.
Example
host1(config)#ipv6 http port 8080
Chapter 27: Configuring Service Manager
691