[26-15] Pcr; [26-16] Scr; [26-17] Mbs - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

radius ignore atm-pcr
radius ignore atm-scr
radius ignore atm-mbs
Copyright © 2010, Juniper Networks, Inc.
Use the no version to restore the default, disable.

[26-15] PCR

Use the following command to manage the PCR RADIUS attribute.
radius ignore atm-pcr
Use to cause the PCR attribute to be ignored in Access-Accept messages.
You can control this behavior by enabling or disabling this command.
See radius ignore
Example
host1(config)#radius ignore atm-pcr enable
Use the no version to restore the default, disable.

[26-16] SCR

Use the following command to manage the SCR RADIUS attribute.
radius ignore atm-scr
Use to cause the SCR attribute to be ignored in Access-Accept messages.
You can control this behavior by enabling or disabling this command.
See radius ignore
Example
host1(config)#radius ignore atm-scr enable
Use the no version to restore the default, disable.

[26-17] MBS

Use the following command to manage the MBS RADIUS attribute.
radius ignore atm-mbs
Use to cause the MBS attribute to be ignored in Access-Accept messages.
You can control this behavior by enabling or disabling this command.
See radius ignore
Example
host1(config)#radius ignore atm-mbs enable
Chapter 3: Configuring RADIUS Attributes
219