Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 712

JunosE 11.3.x Broadband Access Configuration Guide
time
volume
674
Use the volume-time keyword to collect statistics about both the volume of traffic
and the duration of the service session.
Example
host1(config)#service-management service-session-profile vodISP1
host1(config-service-session-profile)#statistics volume-time
Use the no version to disable statistics collection.
NOTE: Service Manager statistics collection is a three-part procedure. You
must configure statistics information in the service definition macro file,
enable statistics collection by either RADIUS or the CLI, and also enable
statistics collection for the policy referenced in the service macro using the
statistics enabled keyword in the command used for policy attachment in
the profile. See "Configuring Service Manager Statistics" on page 677.
See statistics
Use to specify the maximum amount of time that the service session can be active for
the subscriber.
The router immediately terminates the subscriber's service session when the specified
time is exceeded.
The range is 0–16777251 seconds.
Example
host1(config)#service-management service-session-profile vodISP1
host1(config-service-session-profile)#time 6000
Use the no version to delete the time attribute from the service session profile.
See time
Use to specify the maximum amount of bandwidth that can use the service.
The router immediately terminates the subscriber's service session when the specified
traffic volume is exceeded.
NOTE: The volume attribute uses values captured by the Service Manager
statistics feature to determine when the threshold is exceeded. Therefore,
you must configure and enable statistics collection to use this attribute.
See "Configuring Service Manager Statistics" on page 677.
The range is 0–16777251MB.
Copyright © 2010, Juniper Networks, Inc.