Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 482

JunosE 11.3.x Broadband Access Configuration Guide
444
Table 92: show l2tp tunnel Output Fields (continued)
Field Name
Effective administrative state
State
Local and peer tunnel id
Sub-interfaces:
Statistics
Control channel statistics
Receive window size
Receive ZLB
Receive out-of-sequence
Receive out-of-window
Transmit window size
Transmit ZLB
Transmit queue depth
Field Description
Most restrictive of the following administrative states:
E Series router, destination, and tunnel. This setting,
rather than the administrative state of the tunnel,
determines whether the router can create new
sessions on a tunnel or whether the sessions on a
tunnel are disabled or not.
Status of the enabled tunnel:
idle
connecting
established
disconnecting
Names the router used to identify the tunnel locally
and remotely
Sub-interface information for the enabled tunnel:
total—Number of sessions that the router has
created on this tunnel
active—Number of operational sessions on the
tunnel
failed—Number of requests that did not reach an
operational state
Information about the traffic sent and received
Tunnel control channel information
Number of packets that the peer can transmit without
receiving an acknowledgment from the router.
Number of acknowledgments that the router has
received from the peer.
Number of received control packets that were out of
order.
Number of packets that arrived at the router outside
the receiving window.
Number of packets that the router can transmit before
receiving an acknowledgment from the peer.
Number of acknowledgments that the router has sent
to the peer.
Number of packets that the router is waiting to send
to the peer, plus the number of packets for which the
peer has not yet acknowledged receipt.
Copyright © 2010, Juniper Networks, Inc.