Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 456

JunosE 11.3.x Broadband Access Configuration Guide
l2tp dial-out dormant-timer-value
l2tp dial-out max-buffered-triggers
l2tp dial-out session delete
l2tp dial-out session reset
418
Use the no version to set the connecting timer to the default, 30 seconds.
See l2tp dial-out connecting-timer-value
Use to set how long the dial-out session waits in the dormant state for a new trigger
after the associated L2TP outgoing call ends.
If no trigger is received before the dormant timer expires, the dial-out session is deleted.
The range is 0–3600 seconds.
Example
host1(config)#l2tp dial-out dormant-timer-value 300
Use the no version to set the dormant timer to the default, 300 seconds (5 minutes).
See l2tp dial-out dormant-timer-value
Use to set the maximum number of buffered trigger packets held for any dial-out
session pending the successful establishment of the L2TP session. Once the session
is established, the buffered trigger packets are transmitted.
Trigger packets received when the maximum number of triggers are already buffered
are discarded.
The range of values is 0–50.
Example
host1(config)#l2tp dial-out max-buffered-triggers 50
Use the no version to set the number of trigger buffers to the default, 0.
See l2tp dial-out max-buffered-triggers
Use to delete a dial-out session.
Closes any L2TP outgoing call associated with the dial-out session.
Example
host1#l2tp dial-out session delete 10.10.0.0
There is no no version.
See l2tp dial-out session delete
Use to force the dial-out session to the dormant state where it remains until the dormant
timer expires or it receives a new trigger.
Closes any L2TP outgoing call associated with the dial-out session.
Example
Copyright © 2010, Juniper Networks, Inc.