Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 49

ip-router-name
ipv6-local-interface
ipv6-router-name
Copyright © 2010, Juniper Networks, Inc.
Use to preallocate an IP address for the remote B-RAS user before authenticating the
remote user.
The address is passed as a hint in the authentication request.
Example
host1(config-domain-map)#ip-hint enable
Use the no version to disable the feature.
See ip-hint
Use to assign an IPv4 virtual router to a domain map.
AAA domain map support for IPv4 enables you to provide additional virtual router
assignment capabilities for IPv4 subscribers. If you assign a value other than default
to a layer 2 virtual router, then the access, IPv4, and IPv6 virtual routers are all assigned
the same value, which cannot be changed. If you use RADIUS redirect to assign virtual
routers, you can assign access, IPv4, and IPv6 to the redirection target.
Example
host1(config)#aaa domain-map xyz.com
host1(config-domain-map)#ip-router-name ipv4vr
Use the no version to restore the default router.
See ip-router-name
Use to map a user domain name to an IP version 6 (IPv6) loopback interface.
The local interface identifies the interface information to use on the local (E Series)
side of the subscriber's interface.
Example
host1(config)#aaa domain-map westford.com
host1(config-domain-map)#ipv6-local-interface 2001:db8::8000
Use the no version to delete the entry.
See ipv6-local-interface
Use to map a user domain name to an IPv6 virtual router in Domain Map Configuration
mode.
Example
host1(config)#aaa domain-map westford.com
host1(config-domain-map)#ipv6-router-name vroutv6
Use the no version to delete the entry.
See ipv6-router-name
Chapter 1: Configuring Remote Access
11