Framed-Ip-Address - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x Broadband Access Configuration Guide
radius pppoe nas-port-format unique
radius vlan nas-port-format stacked
Related
Documentation
radius include framed-ip-addr
192
adapter 1 vpi 7 vpi 17
Example 2—Sets the field widths for Gigabit Ethernet and 10-Gigabit Ethernet interfaces
host1(config)#radius nas-port-format extended ethernet field-widths slot 4 adapter
1 port 3 vlan 12
Use the no version to restore the default behavior of the radius nas-port-format
command.
Use to set the NAS-Port attribute to a unique value for subscribers on PPPoE interface.
This unique value is derived from the subscriber's profileHandle.
See radius pppoe nas-port-format unique
Example
host1(config)#radius pppoe nas-port-format unique
Use the no version to return to the default, in which the value is determined by the
interface.
Use to include the S-VLAN ID, in addition to the VLAN ID, in the NAS-Port attribute for
subscribers on Ethernet interfaces.
The VLAN ID is always included whether the S-VLAN ID inclusion feature is enabled
or disabled.
The radius pppoe nas-port-format unique command overrides this command.
See radius vlan nas-port-format stacked
Example
host1(config)#radius vlan nas-port-format stacked
Use the no version to return to the default, in which the S-VLAN ID is not included.
Monitoring the NAS-Port-Format RADIUS Attribute on page 304

[8] Framed-IP-Address

Use the following command to manage the Framed-IP-Address RADIUS attribute.
radius include framed-ip-addr
Use to include the Framed-IP-Address attribute in Acct-Start and Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
For RADIUS to include this attribute, an IP address must be assigned to the subscriber.
See radius include
Copyright © 2010, Juniper Networks, Inc.