Virtual Router; Targets; Sessions; Table 74: Chassis Operational States - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x Broadband Access Configuration Guide
412

Table 74: Chassis Operational States

State Description
inService Dial-out service is operational at the chassis level.
initializationFailed Dial-out service could not obtain enough system resources for basic
operation. All configuration commands fail, and the dial-out service does
not function.

Virtual Router

Table 75 on page 412 describes the operational states of the virtual router.

Table 75: Virtual Router Operational States

State Description
inService Dial-out service is operational for the virtual router.
initPending Dial-out service is waiting for the virtual router to be operational. Targets
defined within the virtual router are not functional.
down The dial-out interface for this virtual router is down. Targets defined within
the virtual router are not functional.

Targets

Table 76 on page 412 describes the operational states of the targets.

Table 76: Target Operational States

State Description
inService Dial-out route is up and operational.
inhibited Dial-out service cannot obtain sufficient resources to handle triggers, and
all triggers are discarded. When resources become available, a target can
transition from inhibited to inService.
Note that sessions within an inhibited target that are already in the process
of connecting or are in the inService state are not affected by this condition.
down There are insufficient resources to support the creation of a dial-out route
for the target. When resources become available, the target can transition
to inService.
Note that sessions within a down target that are already in the process of
connecting or are in the inService state are not affected by this condition.

Sessions

Table 77 on page 413 describes operational states of the sessions.
Copyright © 2010, Juniper Networks, Inc.