license service-management
Managing and Activating Service Sessions
Copyright © 2010, Juniper Networks, Inc.
not enabled. If you disable the Service Manager license and more than 10 subscriber
sessions exist, you cannot enable any new sessions—however, all existing active subscriber
sessions continue to function.
For information about the maximum number of subscriber sessions supported, see JunosE
Release Notes, Appendix A, System Maximums.
Use to specify the Service Manager license and enable full Service Manager application
support—if the license is not enabled, you are limited to 10 subscriber sessions.
The license is a unique string of up to 15 alphanumeric characters.
NOTE: Obtain the license from Juniper Networks Customer Service or your
Juniper Networks sales representative.
Example
host1(config)#license service-management 123456789
Use the no version to disable the license.
See license service-management
You can use either RADIUS or the CLI to manage, activate, and deactivate service sessions.
The following list describes some of the differences between using RADIUS and the CLI
to manage the Service Manager application.
RADIUS-based login and RADIUS CoA support:
Provides dynamic activation and deactivation based on subscriber service selection
Provides greater flexibility and efficient management for a large number of subscribers
and services
Enables you to use mutual exclusion (mutex) groups to create mutex services
(RADIUS CoA only)
CLI-based support:
Provides static activation and deactivation for subscribers who are always logged
in
Is useful for testing new service definitions
Enables you to preprovision services that you can activate later
Chapter 27: Configuring Service Manager
651
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 and is the answer not in the manual?