Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 774

JunosE 11.3.x Broadband Access Configuration Guide
deactivating..........................................................662
with IPv4 services..............................................660
IPv6-Acct-Input-Gigawords [26-155] .........................229
IPv6-Acct-Input-Octets [26-151] ..................................229
IPv6-Acct-Input-Packets [26-153]...............................229
IPv6-Acct-Output-Gigawords [26-156].....................229
IPv6-Acct-Output-Octets [26-152]..............................229
IPv6-Acct-Output-Packets [26-154] ..........................229
Ipv6-Local-Interface (RADIUS attribute
26-46)..................................................................................222
Ipv6-NdRa-Prefix (RADIUS attribute 26-46)............227
IPv6-NdRa-Prefix attribute
used for IPv6 Neighbor Discovery
from Access-Accept messages......................88
IPv6-Primary-DNS (RADIUS attribute 26-47)..........222
Ipv6-Secondary-DNS (RADIUS attribute
26-46)..................................................................................222
IPv6-Virtual-Router (RADIUS attribute 26-45).........221
K
key command................................................30, 78, 244, 252
L
L2C-Down-Stream-Data (RADIUS attribute
26-93)..................................................................................226
L2C-Information (RADIUS attribute 26-81)...............226
L2C-Up-Stream-Data (RADIUS attribute
26-92)..................................................................................226
L2TP (Layer 2 Tunneling Protocol)
defining............................................................................335
high availability considerations..............................342
implementation............................................................337
license...............................................................................341
modifying LAC default settings...................344, 383
monitoring......................................................................425
peer resynchronization..............................................388
rx speed ..........................................................................364
sessions supported......................................................341
silent failover.................................................................388
tunnel selection...........................................................369
tunnel switch profiles.................................................392
L2TP access concentrator. See LAC
l2tp commands....................................................................384
disconnect-cause.......................................................384
failover-resync ..............................................................391
l2tp checksum..............................................................345
l2tp destination lockout-test..................................368
l2tp destination lockout-timeout.........................368
l2tp destination profile......................................374, 377
736
l2tp destruct-timeout...............................................346
l2tp disable calling-number avp...........................349
l2tp disable challenge...............................................358
l2tp disconnect-cause..............................................384
l2tp drain........................................................................346
l2tp drain destination................................................346
l2tp drain tunnel..........................................................346
l2tp fail-over-within-preference............................369
l2tp failover-resync ...........................................388, 391
l2tp ignore-receive-data-sequencing.................358
l2tp ignore-transmit-address-change................368
l2tp reject-transmit-address-change.................368
l2tp retransmission.....................................................349
l2tp short-drain-timeout..........................................346
l2tp shutdown...............................................................347
l2tp shutdown destination.......................................347
l2tp shutdown session...............................................347
l2tp shutdown tunnel.................................................347
l2tp switch-profile.......................................................397
l2tp tunnel default-receive-window....................385
l2tp tunnel idle-timeout...........................................383
l2tp tunnel test.............................................................383
l2tp tunnel-switching.......................................382, 397
l2tp unlock destination.............................................368
l2tp unlock-test destination...................................368
l2tp weighted-load-balancing command.........369
max-sessions command.................................374, 378
See also show l2tp commands
L2TP dial-out
before configuring........................................................416
configuring.......................................................................417
dial-out process.............................................................411
network model..............................................................410
operational states.........................................................411
outgoing call setup details........................................411
Access-Accept message...................................411
Access-Request message.................................411
mutual authentication........................................411
outgoing call successful....................................411
route installation...................................................411
overview.........................................................................409
references.......................................................................416
route..................................................................................410
session.............................................................................410
target................................................................................410
trigger...............................................................................410
l2tp dial-out commands....................................................416
l2tp dial-out connecting-timer-value...................417
l2tp dial-out dormant-timer-value........................417
Copyright © 2010, Juniper Networks, Inc.