[123] Delegated-Ipv6-Prefix - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

radius include framed-ipv6-pool
radius include delegated-ipv6-prefix
Copyright © 2010, Juniper Networks, Inc.
radius include framed-ipv6-pool
Use to include the Framed-Ipv6-Pool attribute in Acct-Start or Acct-Stop messages.
You can control inclusion of the Framed-Ipv6-Pool attribute by enabling or disabling
this command.
For this attribute, the value received from the RADIUS server in the Access-Accept
message is used in the accounting messages.
If the IPv6 pool name is configured in the AAA domain map using the CLI and is not
returned from RADIUS server, the Acct-Start, Acct-Stop, or Interim-Acct messages
report the value configured in the domain map.
See radius include
Example
host1(config)#radius include framed- ipv6-pool acct-start enable
Use the no version to restore the default, disable.

[123] Delegated-Ipv6-Prefix

Use the following command to manage the Delegated-Ipv6-Prefix RADIUS attribute.
radius include delegated-ipv6-prefix
Use to include the Delegated-Ipv6-Prefix attribute in Acct-Start or Acct-Stop messages.
You can control inclusion of the Delegated-Ipv6-Prefix attribute by enabling or disabling
this command.
For this attribute, the value received from the RADIUS server in the Access-Accept
message is used in the accounting messages.
When prefix delegation occurs, an immediate-update (if enabled) message, which
contains the delegated prefix information, is sent to the RADIUS server.
When the prefix to be delegated to clients is obtained from the IPv6 local address
server than the RADIUS server and the aaa dhcpv6-delegated-prefix
delegated-ipv6-prefix command is configured, the delegated prefix is sent to the
RADIUS server in the Delegated-Ipv6-Prefix attribute in the immediate accounting,
Acct-Stop, or Interim-Acct messages.
When the prefix to be delegated to clients is allocated from the IPv6 local address
server and the aaa dhcpv6-delegated-prefix delegated-ipv6-prefix command is not
configured, the delegated prefix is sent to the RADIUS server in the Framed-Ipv6-Prefix
attribute in the immediate accounting, Acct-Stop, or Interim-Acct messages.
For static interfaces, although the prefix configured using the CLI command is used for
DHCPv6 Prefix Delegation instead of the value returned by the RADIUS server, the
immediate accounting, Acct-Stop, or Interim-Acct messages contain the prefix returned
Chapter 3: Configuring RADIUS Attributes
215