Using The Set Dhcp Relay Agent Sub-Option Command To Enable Option 82 Suboption Support - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual
Software for e series broadband services routers broadband access configuration guide
Hide thumbs
Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12:
- Configuration manual (750 pages)
Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Using the set dhcp relay agent sub-option Command to Enable Option 82
Suboption Support
NOTE: We recommend that you use the set dhcp relay agent sub-option
command for new option 82 suboption configurations. However, JunosE
Software continues to support the set dhcp relay agent command, with
option 82 suboptions, to provide backward-compatibility for existing scripts.
You use the set dhcp relay agent sub-option command to enable support for a specific
DHCP relay agent option 82 suboption—Agent Circuit ID (suboption 1), Agent Remote ID
(suboption 2), and Vendor-Specific (suboption 9). When you issue this command, the
router adds DHCP relay agent information suboption 1 to every packet it relays from a
DHCP client to a DHCP server. The Agent Circuit ID suboption identifies the interface on
which DHCP packets are received. When the packets are received on a LAG interface,
the router clearly identifies the interface.
The suboptions include information from the DHCP relay agent that the DHCP server
can use to implement parameter assignment policies. The DHCP server echoes the
suboptions when it replies to the DHCP client, but the DHCP relay strips the suboptions
before relaying the packets to the client.
The Agent Circuit ID suboption identifies the interface on which the DHCP packets are
received. This suboption contains the following information, based on interface type:
ATM interface
[<hostname>|<vrname>:]<interface type> <slot>/<port>[.<sub-if>]:<vpi>.<vci>
Examples:
atm 4/1.2:0.101
relayVr:atm 4/1:0.101
bostonHost:atm 4/1.2:0.101
Ethernet interface
[<hostname>|<vrname>:]<interface type> <slot>/<port>
Examples:
fastEthernet 1/2
relayVr:fastEthernet 1/2
bostonHost:fastEthernet 1/2
Ethernet interface with VLAN
[<hostname>|<vrname>:]<interface type> <slot>/<port>[.<sub-if>]:<vlan id>
Examples:
fastEthernet 1/2.3:4
relayVr:fastEthernet 1/2:4
bostonHost:fastEthernet 1/2.3:4
Ethernet interface with Stacked VLAN
Chapter 20: Configuring DHCP Relay
507
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 and is the answer not in the manual?