[83] Tunnel-Preference; [87] Nas-Port-Id - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

radius include tunnel-assignment-id
radius include tunnel-preference
Copyright © 2010, Juniper Networks, Inc.
radius include tunnel-assignment-id
Use to include the Tunnel-Assignment-Id attribute in Acct-Start or Acct-Stop messages.
You can control inclusion of the Tunnel-Assignment-Id attribute by enabling or disabling
this command.
See radius include
Example
host1(config)#radius include tunnel-assignment-id acct-stop enable
Use the no version to restore the default, enable.

[83] Tunnel-Preference

Use the following command to manage the Tunnel-Preference RADIUS attribute.
radius include tunnel-preference
Use to include the Tunnel-Preference attribute in Acct-Start or Acct-Stop messages.
You can control inclusion of the Tunnel-Preference attribute by enabling or disabling
this command.
See radius include
Example
host1(config)#radius include tunnel-preference acct-start enable
Use the no version to restore the default, enable.

[87] NAS-Port-Id

Use the following commands to manage and show information for the NAS-Port-Id
RADIUS attribute.
aaa intf-desc-format include
radius include nas-port-id
radius override nas-port-id remote-circuit-id
NOTE: For subscribes connected over the LAG interface in DHCP standalone
authenticate mode, RADIUS uses the LAG interface ID for the Nas-Port-Id
attribute.
For more information about subscribers connected over the LAG interface in
DHCP standalone authenticate mode, see "Propagation of LAG Subscriber
Information to AAA and RADIUS" on page 90.
Chapter 3: Configuring RADIUS Attributes
211