Configuring Remote Access - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

CHAPTER 1

Configuring Remote Access

Copyright © 2010, Juniper Networks, Inc.
This chapter describes how to configure remote access to an Juniper Networks E Series
Broadband Services Router. This chapter discusses the following topics:
Remote Access Overview on page 4
Remote Access Platform Considerations on page 5
Remote Access References on page 6
Before You Configure B-RAS on page 6
Remote Access Configuration Tasks on page 6
Configuring a B-RAS License on page 7
Mapping a User Domain Name to a Virtual Router on page 8
Setting Up Domain Name and Realm Name Usage on page 12
Specifying a Single Name for Users from a Domain on page 16
Configuring RADIUS Authentication and Accounting Servers on page 18
Configuring Local Authentication Servers on page 39
Configuring Tunnel Subscriber Authentication on page 49
Configuring Name Server Addresses on page 50
Configuring Local Address Servers on page 52
Configuring DHCP Features on page 59
Creating an IP Interface on page 59
Configuring AAA Profiles on page 61
Using RADIUS Route-Download Server to Distribute Routes on page 69
Using the AAA Logical Line Identifier to Track Subscribers on page 74
Using VSAs for Dynamic IP Interfaces on page 79
Mapping Application Terminate Reasons to RADIUS Terminate Codes on page 82
Configuring Timeout on page 85
Limiting Active Subscribers on page 87
Notifying RADIUS of AAA Failure on page 87
Configuring Standard RADIUS IPv6 Attributes for IPv6 Neighbor Discovery Router
Advertisements and DHCPv6 Prefix Delegation on page 88
3