Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 307

Table 50: Juniper Networks (Vendor ID 4874) VSA Formats (continued)
Attribute
Number Attribute Name
[26-92] L2C-Up-Stream-Data
[26-93] L2C-Down-Stream-Data
[26-94] Tunnel-Tx-Speed-Method
[26-95] IGMP-Query-Interval
[26-96] IGMP-Max-Resp-Time
[26-97] IGMP-Immediate-Leave
[26-98] MLD-Query-Interval
[26-99] MLD-Max-Resp-Time
[26-100] MLD-Immediate-Leave
[26-110] Acc-Loop-Cir-Id
Copyright © 2010, Juniper Networks, Inc.
Description
Actual upstream rate access loop
parameter (ASCII encoded) as defined in
GSMP extensions for layer2 control (L2C)
Topology Discovery and Line
Configuration—draft-wadhwa-gsmp-
l2control-configuration-00.txt (July 2006
expiration).
Actual downstream rate access loop
parameter (ASCII encoded) as defined in
GSMP extensions for layer2 control (L2C)
Topology Discovery and Line
Configuration—draft-wadhwa-gsmp-
l2control-configuration-00.txt (July 2006
expiration).
The method that the router uses to
calculate the transmit connect speed of
the subscriber's access interface. This
speed is reported in L2TP Transmit (TX)
Speed AVP 24. During the establishment
of an L2TP tunnel session, the LAC sends
AVP 24 to the LNS to convey the transmit
speed of the subscriber's access interface.
IGMP Query Interval
IGMP Maximum Response Time
IGMP Immediate Leave
MLD Query Interval
MLD Maximum Response Time
MLD Immediate Leave
Identification of the subscriber node
connection to the access node
Chapter 6: RADIUS Attribute Descriptions
Subtype
Length Length Value
len sublen string: actual
upstream rate access
loop parameter (ASCII
encoded)
len sublen string: actual
downstream rate
access loop
parameter (ASCII
encoded)
12 6 integer:
1 = static-layer2, TX
speed based on static
layer 2 settings;
2 =dynamic-layer2, TX
speed based on
dynamic layer 2
settings;
3 = qos, TX speed
based on QoS
settings;
4 = actual, TX speed
that is the lesser of
the dynamic-layer2
value or the qos value
12 6 integer: 4-octet
12 6 integer: 4-octet
12 6 4-octet integer:
0 = disabled
1 = enabled
12 6 integer: 4-octet
12 6 integer: 4-octet
12 6 4-octet integer:
0 = disabled
1 = enabled
len sublen string: up to 63 ASCII
characters
269