Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 301

Table 50: Juniper Networks (Vendor ID 4874) VSA Formats (continued)
Attribute
Number Attribute Name
[26-10] Ingress-Policy-Name
[26-11] Egress-Policy-Name
[26-12] Ingress-Statistics
[26-13] Egress-Statistics
[26-14] Service-Category
[26-15] PCR
[26-16] SCR
[26-17] Mbs
[26-18] Init-CLI-Access-Level
[26-19] Allow-All-VR-Access
[26-20] Alt-CLI-Access-Level
[26-21] Alt-CLI-Vrouter-Name
Copyright © 2010, Juniper Networks, Inc.
Description
Input policy name to apply to B-RAS user's
interface
Output policy name to apply to B-RAS
user's interface
Enable or disable input statistics on B-RAS
user's interface
Enable or disable output statistics on
B-RAS user's interface
ATM service category to apply to B-RAS
user's interface
Peak cell rate
4-octet integer
Sustained cell rate
4-octet integer
Maximum burst rate
4-octet integer
Specifies the initial level of access to CLI
commands
See the enable command in the
Passwords and Security chapter in JunosE
System Basics Configuration Guide.
Specifies user access to all virtual routers
See the enable command in the
Passwords and Security chapter in JunosE
System Basics Configuration Guide.
Specifies other levels of access to CLI
commands
See the enable command in chapter
Passwords and Security in JunosE
System Basics Configuration Guide.
For restricted users, specifies other VRs
that the user may access.
See the enable command in chapter
Passwords and Security in JunosE
System Basics Configuration Guide.
Chapter 6: RADIUS Attribute Descriptions
Subtype
Length Length Value
len sublen string:
input-policy-name
len sublen string:
output-policy-name
12 6 integer: 0 = disable,
1 = enable
12 6 integer: 0 = disable,
1 = enable
12 6 integer: 1= UBR,
2 = UBR PCR,
3 = NRT VBR,
4 = CBR
5 = RT VBR,
12 6 integer: 4-octet
12 6 integer: 4-octet
12 6 integer: 4-octet
len sublen single attribute: enter
0, 1, 5, 10, or 15
len sublen integer: 0 = disable,
1 = enable
len sublen single attribute; enter
0, 1, 5, 10, or 15
len sublen string:
virtual-router-name
263