Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 228

JunosE 11.3.x Broadband Access Configuration Guide
radius include nas-port
radius nas-port-format
radius nas-port-format extended atm
radius nas-port-format extended ethernet
190
radius nas-port-format extended
radius pppoe nas-port-format unique
radius vlan nas-port-format stacked
NOTE: For subscribers connected over the LAG interface in DHCP standalone
authenticate mode, RADIUS derives a unique value from the subscriber's
profileHandle and uses the value for the Nas-Port attribute. The radius
nas-port-format, radius vlan nas-port-format stacked, and radius pppoe
nas-port-format commands do not affect the value of the Nas-Port attribute.
For more information about subscribers connected over the LAG interface in
DHCP standalone authenticate mode, see "Propagation of LAG Subscriber
Information to AAA and RADIUS" on page 90.
Use to include the NAS-Port attribute in Access-Request, Acct-Start, and Acct-Stop
messages.
You control inclusion of the attribute by enabling or disabling this command.
Example
host1(config)#radius include nas-port acct-start enable
Use the no version to restore the default, enable.
See radius include
Use to set the NAS-Port format attribute for ATM and Ethernet only to either 0ssssppp
or ssss0ppp.
The format is a 4-octet integer. The remaining bits are not changed (8 bits VPI and 16
bits VCI; or 12 bits S-VLAN and 12 bits VLAN).
The s indicates a bit used to represent the slot; the p indicates a bit used to represent
the port from which the authentication request originates.
See radius nas-port-format
Example: If the PPP user is received on a VC from the card in slot 7, port 2, then the bit
pattern is either 00111010 (for 0ssssppp) or 01110010 (for ssss0ppp).
host1(config)#radius nas-port-format Ossssppp
Use the no version to restore the default.
Copyright © 2010, Juniper Networks, Inc.