Including Or Excluding Attributes In Radius Messages - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Broadband Access Configuration Guide
For information about enabling the QoS downstream rate application to obtain
downstream rates from the Actual-Data-Rate-Downstream [26-130] DSL Forum VSA,
see the Configuring the Downstream Rate Using QoS Parameters chapter in JUNOSe
Quality of Service Configuration Guide.
For a more detailed description of the DSL Forum VSAs, see "DSL Forum VSAs" on
page 270 .
radius include dsl-forum-attributes

Including or Excluding Attributes in RADIUS Messages

For many attributes, you can configure the router to include or exclude the attribute
in RADIUS messages.
radius include
232
CLI Commands Used to Modify RADIUS Attributes
Use to include the set of DSL Forum VSAs in Access-Request, Acct-Start, and
Acct-Stop messages that the router sends to RADIUS. If you enable inclusion of
the DSL Forum VSAs in Acct-Stop messages, the router also includes the VSAs
in Interim-Acct messages.
You can control inclusion of the DSL Forum VSAs in the specified message type
by enabling or disabling this command. Inclusion is disabled by default.
When you enable inclusion of the DSL Forum VSAs for a specified message type,
the router includes in that message all of the DSL Forum attributes that it receives
from the DSLAM.
Example
host1(config)#radius include dsl-forum-attributes access-request enable
Use the no version to restore the default behavior, disable.
See radius include dsl-forum-attributes
Use to enable or disable the inclusion of RADIUS attributes in Acct-On, Acct-Off,
Access-Request, Acct-Start, and Acct-Stop messages.
Examples
host1(config)#radius include ingress-policy-name acct-start enable
host1(config)#radius include tunnel-type access-request disable
Use the no version to restore the default, disable.
See radius include