Configuring Radius Return Attributes Policies (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual

NSM Infranet Controller Configuration Guide
Related
Documentation

Configuring RADIUS Return Attributes Policies (NSM Procedure)

80
Table 22: RADIUS Clients Configuration Details (continued)
Option Function
Shared Secret Validates communications between the
Infranet Controller and network access
device.
Make/Model Specifies the dictionary of RADIUS
attributes to be used by the Infranet
Controller when communicating with this
client.
Location Specifies the location group to use with
Group this network access device.
Support Allows the Infranet Controller to send
Disconnect unsolicited disconnect requests to the
Messages network access device. When a user
session is deleted on the Infranet
Controller, the disconnect messages
cause the user's session to be terminated
immediately, and all session information
is removed.
Enabled Enables the RADIUS clients.
Configuring Location Groups (NSM Procedure) on page 76
Configuring RADIUS Return Attributes Policies (NSM Procedure) on page 80
Configuring RADIUS Request Attributes Policies (NSM Procedure) on page 83
You can configure RADIUS attributes policies on the Infranet Controller to send return
list attributes to an 802.1X network access device. You can also configure other functions
on a network access device's port based on the role assigned to the user who is currently
using that port.
To configure RADIUS attributes policies:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the Infranet Controller device for
2.
which you want to configure RADIUS return attributes policies.
Your Action
Enter the shared secret.
The Infranet Controller supports
shared secrets of up to 127
alphanumeric characters, including
spaces and the following special
characters:
~!@#$%^&*()_+|\=-'{}[]:"';<>?/.,
Select the make or model.
Select the location group.
Select this option to send terminate
session requests to network access
devices that support RFC 3576.
Select this option to enable RADIUS
clients.
Copyright © 2010, Juniper Networks, Inc.