Including Or Excluding Attributes In Radius Messages; Ignoring Attributes When Receiving Access-Accept Messages - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

Including or Excluding Attributes in RADIUS Messages

radius include
Related Topics

Ignoring Attributes When Receiving Access-Accept Messages

radius ignore
Copyright © 2010, Juniper Networks, Inc.
When you enable inclusion of the DSL Forum VSAs for a specified message type, the
router includes in that message all of the DSL Forum attributes that it receives from
the DSLAM.
Example
host1(config)#radius include dsl-forum-attributes access-request enable
Use the no version to restore the default behavior, disable.
See radius include dsl-forum-attributes
For many attributes, you can configure the router to include or exclude the attribute in
RADIUS messages.
Use to enable or disable the inclusion of RADIUS attributes in Acct-On, Acct-Off,
Access-Request, Acct-Start, and Acct-Stop messages.
Examples
host1(config)#radius include ingress-policy-name acct-start enable
host1(config)#radius include tunnel-type access-request disable
Use the no version to restore the default, disable.
See radius include
To see a list of the attributes that you can include or exclude, see Monitoring Included
RADIUS Attributes on page 301
You can configure the router to ignore or use many attributes that it receives in
Access-Accept messages.
Use to specify that a RADIUS attribute be ignored or be accepted from Access-Accept
messages.
Use the enable keyword to specify that the RADIUS client ignore the attribute from
the RADIUS server or the disable keyword to use the attribute.
Examples
host1(config)#radius ignore atm-scr enable
host1(config)#radius ignore framed-ip-netmask disable
Use the no version to restore the default, enable.
See radius include
Chapter 3: Configuring RADIUS Attributes
229