Configuring Encapsulation Type Lockout For Pppoe Clients - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide
svlan id
vlan id

Configuring Encapsulation Type Lockout for PPPoE Clients

544
Use the no version to restore the default value, 9100.
See svlan ethertype.
Use to assign S-VLAN IDs and VLAN IDs to VLAN subinterfaces.
Use S-VLAN ID and VLAN ID numbers that are in the range 0–4095 and that are unique
within the Ethernet interface.
Issue the svlan id command before any upper bindings are made, such as IP or PPPoE.
Example
host1(config-if)#svlan id 4 255
There is no no version.
See svlan id.
Use to specify the VLAN ID.
Use a VLAN ID that is in the range 0–4095 and is unique within the Ethernet interface.
Issue the vlan id command before any upper bindings are made, such as IP or PPPoE.
Use the optional keyword untagged to specify that frames be sent untagged. The
keyword is valid only for VLAN ID 0, which can receive tagged frames but sends out
untagged frames.
Example
host1(config-if)#vlan id 400
There is no no version.
See vlan id.
In configurations with dynamic PPPoE subinterfaces over static PPPoE major interfaces,
you can configure dynamic encapsulation type lockout for the PPPoE clients associated
with a dynamic PPPoE subinterface column. Using this feature enables you to temporarily
prevent the static PPPoE major interface from autodetecting, accepting, and creating
dynamic PPPoE subinterface columns for a configurable time period.
By default, encapsulation type lockout is disabled for PPPoE clients. To configure a
lockout time range for the PPPoE clients associated with the dynamic PPPoE subinterface
columns on the PPPoE major interface, use the pppoe auto-configure command with
the lockout-time keyword. You can also use the show pppoe interface lockout-time
command to display detailed information about the current lockout condition for each
PPPoE client, and the pppoe clear lockout interface command to clear (reset) the
lockout condition for an individual PPPoE client.
Copyright © 2010, Juniper Networks, Inc.