Ethernet Oam Link-Fault Management Platform Considerations; Module Requirements; Interface Specifiers; Configuring Ieee 802.3Ah Oam Link-Fault Management - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

Ethernet OAM Link-Fault Management Platform Considerations

Module Requirements

Interface Specifiers

Copyright © 2010, Juniper Networks, Inc.
You can configure 802.3ah link-fault management on the following E Series routers:
E120 router
E320 router
ERX1440 router
ERX1410 router
ERX710 router
ERX705 router
ERX310 router
For information about the modules that support 802.3ah link-fault management on
ERX14xx models, ERX7xx models, and the ERX310 router:
See ERX Module Guide, Table 1, Module Combinations for detailed module specifications.
See ERX Module Guide, Appendix A, Module Protocol Support for information about the
modules that support 802.3ah link-fault management.
For information about the modules that support 802.3ah link-fault management on the
E120 and E320 routers:
See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support 802.3ah link-fault management.
The configuration task examples in this chapter use the format for ERX7xx models,
ERX14xx models, and the ERX310 router to specify 802.3ah link-fault management
For example, the following command specifies a Gigabit Ethernet interface on port 0 of
an I/O module in slot 4.
host1(config)#interface gigabitEthernet 4/0
When you configure a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface on
E120 or E320 routers, you must include the adapter identifier as part of the interface
specifier. For example, the following command specifies a Gigabit Ethernet interface on
port 0 of the IOA installed in the upper adapter bay of slot 3.
host1(config)#interface gigabitEthernet 3/0/0
For more information about interface types and specifiers on E Series models, see Interface
Types and Specifiers in JunosE Command Reference Guide.
Chapter 7: Configuring IEEE 802.3ah OAM Link-Fault Management
225