Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 321

Copyright © 2010, Juniper Networks, Inc.
peer-primary-wins-address—IP address to be used in negotiation of the peer
primary WINS address
peer-secondary-wins-address—IP address to be used in negotiation of the peer
secondary WINS address
NOTE: The command displays the authentication status as "none" for any parameters
not provided by the authentication server.
peer-ipv6–interface-id—IPv6 interface Identifier of the peer returned in an
authentication grant from the RADIUS server
Authentication statistics—Shows statistics accumulated since the session was
established
up-time—Time the session has been up, in seconds
in-octets—Number of octets received on the interface
out-octets—Number of octets transmitted out the interface
in-packets—Number of packets received on the interface
out-packets—Number of packets transmitted out the interface
PAP protocol configuration
request-timeout—Maximum time, in seconds, to wait for an authentication request
packet
CHAP protocol configuration
name—Name to be used in challenge packets
challenge-retry—Maximum number of challenge packets to be transmitted
challenge-timeout—Frequency, in seconds, of challenge packet retransmission
minimum-challenge-length—Minimum length of challenge packet
maximum-challenge-length—Maximum length of challenge packet; the size of
the challenge used for each challenge packet is a random number between
minimum-challenge-length and maximum-challenge-length
minimum-rechallenge-timeout—Minimum time, in seconds, before initiating a
rechallenge to peer
maximum-rechallenge-timeout—Maximum time, in seconds, before initiating a
rechallenge to peer; the actual time before a rechallenge is a random number
between minimum-rechallenge-timeout and maximum-rechallenge-timeout
EAP protocol configuration
Chapter 8: Configuring Point-to-Point Protocol
289