Configuring Dynamic Pppoe Over Static Pppoe With Ethernet And Vlan Interface Columns; Figure 50: Dynamic Pppoe Over Static Pppoe With Non-Vlan Interface - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

Configuring Dynamic PPPoE over Static PPPoE with Ethernet and VLAN Interface Columns

Copyright © 2010, Juniper Networks, Inc.

Figure 50: Dynamic PPPoE over Static PPPoE with Non-VLAN Interface

Columns
To configure an Ethernet interface without VLANs to support a dynamic PPPoE
subinterface:
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet interface.
1.
host1(config)#interface fastEthernet 4/1
Assign an IP address and mask.
2.
host1(config-if)#ip address 192.6.129.5 255.255.255.0
Specify PPPoE as the encapsulation method on the interface.
3.
host1(config-subif)#encapsulation pppoe
This command creates the static PPPoE major interface.
Assign a profile to the PPPoE major interface.
4.
host1(config-subif)#pppoe profile pppoeProfile3
Configure the interface to detect and accept dynamic PPPoE subinterfaces.
5.
host1(config-subif)#pppoe auto-configure
Figure 51 on page 534 shows dynamic PPPoE subinterface columns and illustrates an
alternative method for PPPoE to support multiple IP sessions over each VLAN.
Chapter 17: Configuring Dynamic Interfaces
533