Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 700

JunosE 11.2.x Link Layer Configuration Guide
profile vlan override bulk-config
shutdown
svlan ethertype
668
host1(config-if)#profile vlan bulk-config myBulkConfig vlanBaseProfile
Use the no version to remove the base profile assignment.
See profile vlan bulk-config.
Use to assign an overriding profile to a single VLAN ID or double-tagged S-VLAN ID.
Using an overriding profile enables you to assign a special profile for the subscribers
associated with a specific DSLAM.
You can also use an overriding profile to troubleshoot the specified VLAN or S-VLAN
by overriding the currently assigned base profile with one that has debugging attributes
enabled.
Use the any keyword to specify a VLAN ID as a wildcard. When you specify the any
keyword with an S-VLAN ID of a DSLAM, all subscribers associated with the DSLAM
will be created with the same profile.
Example 1—Assigns an overriding profile (test1OverridingProfile) to the dynamic VLAN
subinterface with VLAN ID 202
host1(config-if)#profile vlan override bulk-config vlan 202 test1OverridingProfile
Example 2—Assigns an overriding profile (test1DebugProfile) to the S-VLAN subinterface
with S-VLAN ID 100 within the VLAN subinterface with V-LAN ID 202
host1(config-if)#profile vlan override bulk-config svlan 100 202 test1OverridingProfile
Example 3—Removes the overriding profile assignment from the VLAN subinterface
with VLAN ID 202, and restores the original base profile assignment
host1(config-if)#no profile vlan override bulk-config vlan 202 test1OverridingProfile
Use the no version to remove the overriding profile assignment for the VLAN ID or
S-VLAN ID and restore the original base profile assignment.
See profile vlan override bulk-config.
Use to disable an interface.
When you disable a dynamic VLAN subinterface, the shutdown command deletes the
VLAN dynamic subinterface column and removes the dynamic VLAN subinterface.
Example
host1(config-subif)#shutdown
Because the shutdown command removes the dynamic VLAN subinterface from the
router, issuing a subsequent no version of this command has no effect; that is, it does
not restart the disabled subinterface.
See shutdown.
Copyright © 2010, Juniper Networks, Inc.