Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 108

JunosE 11.2.x Link Layer Configuration Guide
show atm map
76
Interface Alias: ATM interface slot #2 port 0
Assigned VC class
PHY Type: oc3, Framing: sonet, TX clocking: line
Loopback: none, Receive FIFO Overruns: 0
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
InPackets: 0
InBytes: 0
InCells: 0
OutPackets: 0
OutBytes: 0
OutCells: 0
InErrors: 0
OutErrors: 0
InPacketDiscards: 0
InByteDiscards: 0
InCellErrors: 0
qos-mode-port disabled
queue 0: traffic class control, bound to ATM2/0
Forwarded packets 643, Bytes 36008
Dropped committed packets 0, Bytes 0
Dropped conformed packets 0, Bytes 0
Dropped exceeded packets 0, Bytes 0
Example 2—Shows a summary of all ATM interfaces
host1#show atm interface brief
Interface Status
--------- --------------
ATM 2/0 up
ATM 2/1 up
ATM 2/2 lowerLayerDown
ATM 2/3 down
ATM 4/0 up
ATM 6/0 lowerLayerDown
See show atm interface.
See show interfaces.
Use to display the list of all configured ATM static maps to remote hosts on an ATM
network.
Field descriptions
Map list—Name of map list and method used to enter the map list. PERMANENT
indicates that the map entry was configured; it was not entered automatically by a
process.
protocol address maps to VCx—Name of protocol, the protocol address, and the
VCD that the address is mapped to (for ATM VCs configured with the atm pvc
command).
VC—Number of the virtual circuit
: dsl-subscriber-class
Configured
VCs
----------
2
3
4
5
2
2
Copyright © 2010, Juniper Networks, Inc.