Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 120

JunosE 11.2.x Link Layer Configuration Guide
show atm vc
88
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
1 interface(s) found
Example 5—Displays the current state of a specific ATM subinterface created on the
PVC with the specified VPI and VCI values
host1#show atm subinterface atm 0/0/0/101
Interface ATM-Prot VCD VPI VCI
----------- -------- --- --- --- ------- ----- ---- ------ ---------
ATM 0/0.101 RFC-1483 101
Auto configure status
Auto configure interface(s)
Detected 1483 encapsulation
Detected dynamic interface
Interface types in lockout
Lockout state (seconds)
------------------------------- --- --- ------- ------- ----
PPPoE
Assigned profile (IP)
Assigned profile (BridgedEnet): none assigned
Assigned profile (PPP)
Assigned profile (PPPoE)
Assigned profile (any)
Assigned VC class
SNMP trap link-status: disabled
Advisory receive speed: 2000
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
1 interface(s) found
See show atm subinterface.
Use to display a summary of all configured ATM virtual circuits (VCs) and reserved VC
ranges.
You can specify one or more of the following keywords individually or in combination:
vpi—Displays VCs on a specific VPI
category—Displays VCs that have a specific service category
status—Displays VCs with a certain status
0
0
14
0
Circuit
Type Encap MTU
0 101 PVC AUTO 9180 up
: dynamic
: PPPoE
: SNAP
: PPPoE
: none
: Min Max Current Elapsed Next
1 300 0
: none assigned
: none assigned
: pppoeprofile
: none assigned
: dsl-subscriber-class
5119
358672
5107
357510
0
0
3
0
Copyright © 2010, Juniper Networks, Inc.
Interface
Status Type
Static
0 1