Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 461

show pppoe subinterface summary
Copyright © 2010, Juniper Networks, Inc.
MTU—Maximum transfer unit (MTU) value; when derived from the PPPoE MTU tag,
the value can only be determined from an active session.
In Octets—Number of octets received on the subinterface
Out Octets—Number of octets transmitted on the subinterface
In Packets—Number of packets received on the subinterface
Out Packets—Number of packets transmitted on the subinterface
Example 1
host1:v0#show pppoe subinterface fastEthernet 1/1.1.1
PPPoE subinterface fastEthernet 1/1.1.1 is operStatusUp
URL String: http://www.urlofinterest.com
MOTM String: a horse walks into a bar
PPPoE subinterface fastEthernet 1/1.1.1 has a session id of 1
PPPoE Statistics
In Octets:
Out Octets: 256
In Packets:
Out Packets: 8
Example 2
host1:v0#show pppoe subinterface full
show pppoe subinterface fullPPPoE subinterface FastEthernet 2/0.11 is
operStatusUp (dynamic)
PPPoE subinterface FastEthernet 2/0.11 has a session id of 8
PPPoE subinterface FastEthernet 2/0.11 has source MAC address
0090.1a40.280a
PPPoE subinterface FastEthernet 2/0.11 has a MTU of 1494
PPPoE Statistics
In Octets: 165922
Out Octets: 108283
In Packets: 3607
Out Packets: 3608
See show pppoe subinterface.
Use to display the operational and administrative status of all configured PPPoE
subinterfaces.
Field descriptions
Total PPPoE subinterfaces—Number of configured PPPoE subinterfaces included
in summary
Administrative Status
Up—Number of subinterfaces not affected by manual administrative intervention
Down—Number of subinterfaces that cannot flow because of manual
administrative intervention
Operational Status
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
480
8
429