Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 643

show vlan subinterface
Copyright © 2010, Juniper Networks, Inc.
IPv6 ND OtherConfig
IPv6 ND SuppressRa
IPv6 ND RaInterval
IPv6 ND RaLifeTime
IPv6 ND ReachableTime
IPv6 ND RaPrefix
IPv6 ND ValidLifetime
IPv6 ND PreferredLifetime
IPv6 ND PrefixOnLink
IPv6 ND PrefixAutoConfig
IPv6 http redirect Url
See show profile.
Use to display configuration and status information for a specified VLAN subinterface
or for all VLAN subinterfaces configured on the router.
Use the summary keyword to display only the counts of all VLAN subinterfaces and
VLAN major interfaces configured on the router.
Use the vlan or svlan keywords to display information about specific VLAN IDs or
S-VLAN IDs.
Field descriptions
Interface—Type and specifier of the VLAN subinterface
Status—Status of the VLAN subinterface: up, down, dormant, lowerLayerDown,
absent
MTU—Maximum allowable size (in bytes) of the MTU for the VLAN subinterface
Svlan Id—S-VLAN ID value, if configured
Vlan Id—VLAN ID value for the VLAN subinterface
Ethertype—S-VLAN Ethertype value, if configured
Type—Type of VLAN subinterface
Static—VLAN or S-VLAN subinterface was configured statically
Dynamic—VLAN or S-VLAN subinterface was configured dynamically
Auto configure interface(s)—Types of dynamic upper interfaces configured with the
auto-configure command: IP or PPPoE
Detected dynamic interface—Type of dynamic upper interface detected during
autoconfiguration: IP, PPPoE, or (if no packet has been received) none
Interface types in lockout—Encapsulation types currently experiencing lockout: IP,
PPPoE, or none
Lockout state (seconds)—Settings of encapsulation type lockout for the upper-layer
encapsulation type indicated
Chapter 17: Configuring Dynamic Interfaces
: Enabled
: Disabled
: 50
: 1800
: 0
: 1234::/64
: 60
: 60
: Enabled
: Enabled
: http://www.google.com
611