Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 601

ip policy
ip redirects
ip route-cache flow sampled
ip route-map ip-subscriber
ip sa-validate
Copyright © 2010, Juniper Networks, Inc.
Use the no version to unmark the interface (the default) so that it does not participate
in NAT translation.
See ip nat.
Use to assign a policy list to the ingress or egress of an interface to which the profile is
attached.
Example
host1(config-profile)#ip policy secondary-input my-policy
Use the no version to remove the association between a policy list and a profile.
See ip policy.
Use to enable the sending of redirect messages if the software is forced to resend a
packet through the same interface on which it was received.
Example
host1(config-profile)#ip redirects
Use the no version to remove the assignment from the profile.
See ip redirects.
Use to enable J-Flow statistics on the interface.
Example
host1(config-profile)#ip route-cache flow sampled
Use the no version to delete J-Flow statistics from the profile.
See ip route-cache flow sampled.
Use to configure an interface for route-map processing and specify the route map that
is applied to the IP interface subscriber.
Example
host1(config-profile)#ip route-map ip-subscriber chicagoRouteMap
Use the no version to delete the route map.
See ip route-map ip-subscriber.
Use to enable source address validation on an IP interface.
Source address validation verifies that a packet has been sent from a valid source
address.
Chapter 17: Configuring Dynamic Interfaces
569