Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 669

atm bulk-config
Copyright © 2010, Juniper Networks, Inc.
userName—RADIUS username
domainName—Domain name
You can optionally supply password information:
passwordUsage—How the dynamic interface uses the password for authentication
purposes
password—Use the password as specified.
password-prefix—Use the password as a prefix to the interface physical location.
The router automatically postpends the physical location of the user to the
password string. The password format is password.slot.port.vpi.vci. The resulting
password string is then used to authenticate the subscriber with the RADIUS server.
password—RADIUS password
If your router is running stateful SRP switchover (high availability), the use of the atm
atm1483 subscriber command to configure RADIUS authentication for subscribers
on dynamic bridged Ethernet interfaces might suspend stateful SRP switchover on
the router or prevent stateful SRP switchover from becoming active. For more
information about using the subscriber management application to bypass this
limitation, see "Authenticating Subscribers on Dynamic Bridged Ethernet over Dynamic
ATM Interfaces" on page 632.
Example 1
host1(config-profile)#atm atm1483 subscriber ip user-prefix boston01
domain myisp password-prefix abc123
Example 2
host1(config-subif)#atm atm1483 subscriber bridgedEthernet user westford003
domain acmecorp.east password xyz123
Use the no version to remove the subscriber.
See atm atm1483 subscriber.
Use to create a bulk-configured VC range on a static ATM AAL5 interface for use by a
dynamic ATM 1483 subinterface.
NOTE: For information about the maximum number of ATM 1483 bulk configurations
supported per chassis, see JunosE Release Notes, Appendix A, System Maximums.
Each VC range consists of one or more nonoverlapping VC subranges. A VC subrange
is a group of VCs that resides within the VPI and VCI ranges you specify.
You can configure multiple VC ranges on an ATM AAL5 interface.
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
637