profile
profile atm1483 bulk-config-name
Configuring Overriding Profile Assignments
Copyright © 2010, Juniper Networks, Inc.
host1(config)#interface atm 5/0.1
host1(config)#interface atm 5/0/0.1
Use the no version to remove the interface or subinterface.
See interface atm.
Use to create a base profile to configure attributes for a dynamic ATM 1483 subinterface.
Specify a profile name of up to 80 alphanumeric characters.
Example
host1(config)#profile atm1483BaseProfile
Use the no version to delete the specified profile if it is not being used by any existing
VC subranges.
NOTE: If VC ranges are configured for the dynamic ATM 1483 subinterface associated
with the base profile you want to delete, you must use the no atm bulk-config command
to remove the VC ranges before you can use the no profile command to remove the
associated base profile.
See profile.
Use to assign the base profile configured for a dynamic ATM 1483 subinterface to the
VC range configured on a static ATM AAL5 interface.
You must specify both of the following:
Name assigned to the VC range on an ATM AAL5 interface, as specified in the atm
bulk-config command
Name assigned to the base profile for a dynamic ATM 1483 subinterface
Example
host1(config-if)#profile atm1483 bulk-config-name myBulkConfig atm1483BaseProfile
Use the no version to remove the profile assignment.
See profile atm1483 bulk-config-name
Configuring overriding profile assignments includes the following tasks:
Assigning an overriding profile to an ATM PVC within a bulk-configured VC subrange
Removing an overriding profile assignment from an ATM PVC
Removing overriding profile assignments from a VC range or VC subrange
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
641