Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 541

baseline hdlc interface
show hdlc interface
Copyright © 2010, Juniper Networks, Inc.
NOTE: The E120 and E320 routers output for monitor and show commands is identical
to output from other E Series routers, except that the E120 and E320 routers output
also includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
Use to set a statistics baseline for Cisco HDLC interfaces. The router implements the
baseline by reading and storing the statistics at the time the baseline is set and then
subtracting this baseline whenever baseline-relative statistics are retrieved.
Example
host1#baseline hdlc interface serial 2/0:1/1
There is no no version.
See baseline hdlc interface.
Use to display statistics for the specified HDLC interfaces.
You can specify the following keywords:
statistics—Displays interface statistics
delta—Specifies that baselined statistics are to be shown
status—Displays the operational status of all configured interfaces
closed—Displays interfaces with administrative status Closed
config—Displays configuration information
down—Displays interfaces with operational status Down
lower-layer-down—Displays interfaces with operational status LowerLayerDown
not-present—Displays interfaces with operational status NotPresent
open—Displays interfaces with administrative status Open
up—Displays interfaces with operational status Up
full—Displays configuration information, status, and statistics
filter—Specifies a CLI output filter
Field descriptions
interface status—State of the interface:
Up—Traffic can flow on the interface
Down—Traffic cannot flow because of a problem in the interface at the current
protocol layer
Chapter 16: Configuring Cisco HDLC
509