Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 684

JunosE 11.2.x Link Layer Configuration Guide
atm bulk-config
atm pvc
interface atm
mpls-relay
652
host1(config-if)#atm bulk-config test2 vc-range 0 2 100 250
Use to create a bulk-configured VC range on a static ATM AAL5 interface for use by a
dynamic ATM 1483 subinterface.
For detailed information about how to use this command, see "atm bulk-config" on
page 637.
Example
host1(config)#atm bulk-config test1 vc-range 0 1 101 600
vc-range 3 5 201 3200
Use the no version to remove the specified VC range from the ATM AAL5 interface, to
remove the specified subranges from the specified VC range, or to remove all subranges
from the specified VC range. The no version also removes any overriding profile
assignments for ATM PVCs within the deleted VC range or VC subrange.
See atm bulk-config.
Use to configure a PVC on an ATM interface.
Specify the VCD, the VPI, the VCI, and the encapsulation type. For more information
about these parameters, see "Creating a Basic Configuration" on page 20 in "Configuring
ATM" on page 3.
You can create a PVC within an existing bulk-configured VC subrange, or a
bulk-configured VC subrange that includes the VPI and VCI values of an existing PVC.
Use the aal0 encapsulation keyword to cause the router to receive raw ATM cells on
this circuit and to forward the cells without performing AAL5 packet reassembly.
Example
host1(config-subif)#atm pvc 10 100 22 aal0
Use the no version to remove the specified PVC.
See atm pvc.
Use to select an ATM interface or ATM 1483 subinterface.
For information about specifying the ATM interface or subinterface, see "interface atm"
on page 640.
Examples
host1(config)#interface atm 5/0.1
host1(config)#interface atm 4/0/2
Use the no version to remove the interface or subinterface.
See interface atm.
Copyright © 2010, Juniper Networks, Inc.