Configuring The Service Category For Data Pvcs - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide

Configuring the Service Category for Data PVCs

cbr
ubr
vbr-nrt
46
You can use individual commands in ATM VC Configuration mode to configure each
supported service category on a data PVC, or to restore the default service category,
unspecified bit rate (UBR) without a peak cell rate (PCR).
For example, the following commands configure a data PVC that uses the constant bit
rate (CBR) service category with a nondefault PCR (10,000 Kbps). Issuing the exit
command causes the configuration to take effect.
host1(config)#interface atm 3/0.3
host1(config-subif)#pvc 6 0/100
host1(config-subif-atm-vc)#cbr 10000
host1(config-subif-atm-vc)#exit
host1(config-subif)#
Use to configure the CBR service category on an ATM data PVC.
You must specify a PCR, in Kbps, in the range 1–149760 (for OC3 ATM modules) or
1–599040 (for OC12 ATM modules).
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
Example
host1(config-subif-atm-vc)#cbr 15000
host1(config-subif-atm-vc)#exit
Use the no version to restore the default service category, UBR without a PCR.
See cbr.
Use to configure the UBR service category on an ATM data PVC.
You can optionally specify a PCR, in Kbps, in the range 0–149760 (for OC3 ATM
modules) or 0–599040 (for OC12 ATM modules).
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
Example
host1(config-subif-atm-vc)#ubr 5000
host1(config-subif-atm-vc)#exit
Use the no version to restore the default service category, UBR without a PCR.
See ubr.
Use to configure the variable bit rate, nonreal time (VBR-NRT) service category on an
ATM data PVC.
You must specify all of the following parameters:
Copyright © 2010, Juniper Networks, Inc.