Table of Contents
Advertisement
Related Topics
Enabling Multiclass MLPPP
Copyright © 2010, Juniper Networks, Inc.
Enable multiclass MLPPP.
1.
See "Enabling Multiclass MLPPP" on page 349.
Configure traffic classes on the multiclass MLPPP interface.
2.
See "Configuring Traffic Classes on Multiclass MLPPP Interfaces" on page 350.
(Optional) Configure fragmentation on the multiclass MLPPP interface.
3.
See "Configuring Fragmentation on Multiclass MLPPP Interfaces" on page 350.
(Optional) Configure reassembly on the multiclass MLPPP interface.
4.
See "Configuring Reassembly on Multiclass MLPPP Interfaces" on page 351.
Multiclass MLPPP Overview on page 345
Example: Configuring Multiclass MLPPP on a Dynamic Interface on page 352
Example: Configuring Multiclass MLPPP on a Static Interface on page 353
You can enable multiclass MLPPP on an MLPPP interface and create a specified number
of multilink classes on it. A maximum number of eight multilink classes are supported
per MLPPP interface.
Before you enable multiclass MLPPP:
Define the QoS traffic classes
See Configuring Traffic Classes That Define Service Levels.
To enable multiclass MLPPP and create a specified number of multilink classes on a
dynamic MLPPP interface:
From Global Configuration mode, create an MLPPP dynamic profile by assigning it
1.
a name.
host1(config)#profile ppp-multilink-profile
Enable multiclass MLPPP and specify the number of multilink classes to create.
2.
host1(config-profile)#ppp multilink multiclass multilink-classes 8
To enable multiclass MLPPP and create a specified number of multilink classes on a
static MLPPP interface:
From Global Configuration mode, specify the individual interface on which you want
1.
to configure multiclass MLPPP.
host1(config)#interface gigabitEthernet 3/0/0
Specify PPPoE as the encapsulation method on the interface.
2.
host1(config-if)#encapsulation pppoe
Create a PPPoE subinterface.
3.
Chapter 10: Configuring Multiclass Multilink PPP
349
Advertisement
Chapters
Table of Contents
Troubleshooting
