Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 89

cbr
encapsulation
Copyright © 2010, Juniper Networks, Inc.
The oam-pvc command enables generation of F5 OAM loopback cells and F5 OAM
VC integrity.
The oam ais-rdi command configures the alarm down count for successive AIS and
RDI alarm cells to 5.
In dsl-subscriber-class:
The encapsulation command sets the encapsulation method to aal5autoconfig.
The ubr command configures the UBR service category without a PCR.
To configure an ATM VC class with systemwide default values, you can issue the vc-class
atm command followed immediately by the exit command. For example, the following
commands create a VC class named default-vc-class. Because no attribute values are
explicitly specified in default-vc-class, the router applies the default values for the
commands listed in Table 8 on page 56. For information about the default value for each
command, see the command descriptions in this section.
! Configure VC class with default values.
host1(config)#vc-class atm default-subscriber-class
host1(config-vc-class)#exit
host1(config)#
To verify the VC class configuration, use the show atm vc-class command. For information
about how to use this command, see "show atm vc-class" on page 96.
Use to configure the CBR service category on an ATM data PVC.
For detailed information about how to use this command, see "cbr" on page 46.
You must issue the exit command from ATM VC Class Configuration mode for the
configuration to take effect.
Example
host1(config-vc-class)#cbr 15000
host1(config-vc-class)#exit
Use the no version to restore the default service category, UBR without a PCR.
See cbr.
Use to configure the encapsulation method on an ATM data PVC.
For detailed information about how to use this command, see "encapsulation" on
page 48.
You must issue the exit command from ATM VC Class Configuration mode for the
configuration to take effect.
Example
host1(config-vc-class)#encapsulation aal5mux ip
host1(config-vc-class)#exit
Chapter 1: Configuring ATM
57