Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 109

show atm oam
Copyright © 2010, Juniper Networks, Inc.
broadcast—Indicates pseudo-broadcasting
connection up—Indicates a point-to-point virtual circuit
Example 1
host1#show atm map
Map list my-map : PERMANENT
ip 192.168.2.10 maps to VC 10 atm 2/0
ip 192.168.2.20 maps to VC 11 atm 2/0
ip 192.168.2.30 maps to VC 12 atm 2/0
Map list other-map : PERMANENT
ip 192.10.2.10 maps to VC 100 atm 2/1
ip 192.10.2.20 maps to VC 101 atm 2/1
ip 192.10.2.30 maps to VC 102 atm 2/1
Example 2
host1#show atm map brief
Map list my-map : PERMANENT
Map list other-map : PERMANENT
Example 3
host1#show atm map my-map
Map list my-map : PERMANENT
ip 192.168.2.10 maps to VC 10 atm 2/0
ip 192.168.2.20 maps to VC 11 atm 2/0
ip 192.168.2.30 maps to VC 12 atm 2/0
See show atm map.
Use to display F4 OAM statistics for an ATM interface.
You must specify a VPI value in addition to the required ATM interface specifier.
You can use the following keywords.
segment—Displays information about segment loopbacks
end-to-end—Displays information about end-to-end loopbacks
To see F4 OAM circuits that are open, use the show atm vc command.
Field descriptions
Sending End To End Loopback Cells—Enabled, disabled
Frequency—Frequency configured on this circuit
End To End OAM CC verification—Whether end-to-end CC verification is enabled or
disabled
OAM CC Type—Whether the circuit is a sink or a source, or both a sink and a source
OAM Current CC state
Chapter 1: Configuring ATM
broadcast
broadcast
broadcast
77