Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 326

JunosE 11.2.x Link Layer Configuration Guide
show ppp interface summary
294
aaa-profile
Authentication status
grant
terminate-reason
PAP protocol configuration
request-timeout
CHAP protocol configuration
name
challenge-retry
challenge-timeout
minimum-challenge-length
maximum-challenge-length
minimum-rechallenge-timeout
maximum-rechallenge-timeout
Example 3—Displays a termination reason (administrative disable) when the operational
status of the interface is down
host1#show ppp interface
PPP interface pos 0/1:1 is lowerDown
PPP interface pos 4/0:1 is lowerDown
PPP interface pos 12/1:1 is lowerDown
3 ppp interfaces found
PPP interface serial 0/0:1/1 is Up
PPP interface serial 0/0:1/2 is Down (administrative disable)
Example 4—Displays information about the PPP interface statistics for IPCP
host1#show ppp interface fastEthernet 2/0.1 statistics ip
PPP interface FastEthernet 2/0.1 is up
LCP protocol statistics
in-keepalive-requests
out-keepalive-requests
in-keepalive-replies
out-keepalive-replies
keepalive-failures
max-renegotiation-terminates
See show ppp interface.
Use to display a summary of all the multilinked and nonmultilinked PPP interfaces
configured on the router.
Field descriptions
PPP Status—Nonmultilinked PPP interfaces
Configuration status—Indicates the configuration state of the PPP interface, IPCP,
IPv6CP , OSINLCP, or MPLS
configured—Interface or protocol is configured
notConfigured—Interface or protocol is not configured
Administrative status—Indicates the administrative state of the PPP interface, IPCP,
IPv6CP , OSINLCP, or MPLS
open—Interface or protocol is administratively enabled
''
false
lower layer down
20 seconds
''
10
4 seconds
16
32
0 seconds
0 seconds
833
830
830
833
0
10
Copyright © 2010, Juniper Networks, Inc.