Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 718

JunosE 11.2.x Link Layer Configuration Guide
show atm subinterface
686
Bulk
Config
Interface Name
------------ ------ --- --- ---------------- ------
ATM AAL5 3/0 test
ATM AAL5 3/0 test
2 profile override(s) found
See show atm bulk-config.
Use to display the current state of all ATM subinterfaces, all ATM subinterfaces
configured on a specified ATM physical interface, or a specific ATM subinterface.
To specify an ATM subinterface for ERX7xx models, ERX14xx models, and ERX310
router, use the slot/port.subinterface format.
slot—Number of the chassis slot
port—Port number on the I/O module
subinterface—Number of the subinterface in the range 1–2147483647
To specify an ATM subinterface for E120 and E320 routers, use the
slot/adapter/port.subinterface format.
slot—Number of the chassis slot
adapter—Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router) or the upper
IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or the lower
IOA bay (E320 router).
port—Port number on the IOA
subinterface—Number of the subinterface in the range 1–2147483647
To display brief summary information for all ATM subinterfaces, or for ATM
subinterfaces configured on a specified ATM physical interface, use the summary
keyword.
To display status information only for ATM subinterfaces with a specific operating
status, use the status keyword with one of the following status values. (See the Status
field description for an explanation of these values.)
dormant
dormantLockout
down
lowerLayerDown
VPI VCI Assigned Profile Status
1 151 overrideProfile1 Active
1 161 overrideProfile1 Active
Copyright © 2010, Juniper Networks, Inc.