Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual page 634

JunosE 11.2.x Link Layer Configuration Guide
show pppoe interface
602
Field descriptions
Type—Interface type
Total—Total number of interfaces on this column
Static—Number of static interfaces on this column
Dynamic—Number of dynamic interfaces on this column
Example
host#show columns
Interface columns:
------------------
Type
-------------------- ---------- ---------- ----------
Bridged Ethernet
IP over ATM
PPP
PPPoE
See show columns.
Use to display summary information about the encapsulation type lockout parameters
configured for PPPoE clients on a dynamic PPPoE subinterface column.
The following field descriptions and example include only the portion of the show
pppoe interface command display relevant to lockout configuration for PPPoE clients.
For more information about using this command, see "show pppoe interface" on page 421
in "Configuring Point-to-Point Protocol over Ethernet" on page 371.
Field descriptions
Lockout Configuration (seconds)—Encapsulation type lockout settings for the PPPoE
client associated with the dynamic PPPoE subinterface column
Min—Minimum lockout time, in seconds
Max—Maximum lockout time, in seconds
Total clients in active lockouts—Number of PPPoE clients currently undergoing
dynamic encapsulation type lockout
Total clients in lockout grace period—Number of PPPoE clients currently in a
lockout grace period; for more information about the lockout grace period, see
"Guidelines for Configuring Encapsulation Type Lockout for PPPoE sessions" on
page 523
Example
host1#show pppoe interface atm 3/0.101
. . .
Lockout Configuration (seconds): Min 5, Max 60
Total clients in active lockouts: 0
Total clients in lockout grace period: 0
Total Static Dynamic
4 2
4 2
22 12
10 5
Copyright © 2010, Juniper Networks, Inc.
2
2
10
5